沼氣的生物脫硫工藝是現在默認效果比較好的一種,下面小編就給大家講一講影響沼氣生物脫硫的幾個因素!
Bio-desulfurization technology of biogas is a better default effect now. The following edition will tell you a few factors affecting bio-desulfurization of biogas!
(1)DO對生物脫硫效果的影響
(1) Effect of DO on biological desulfurization
DO是影響生物脫硫效果的一個重要因素。試驗發現在不同的硫化物負荷下,反應器內都存在一個DO值。此時,反應器對硫化物的去除率比較高(90%以上),絕大部分S2-轉化為S0,基本不生成SO42-。因此,認為DO值與硫化物負荷有關,二者成線性關系。
DO is an important factor affecting the effect of biological desulfurization. It was found that there was a DO value in the reactor under different sulfide loads. At this time, the sulfide removal rate of the reactor is relatively high (more than 90%), most of the S2 - is converted to S0, and no SO42 - is produced. Therefore, it is considered that the DO value is related to the sulfide load, and there is a linear relationship between the DO value and the sulfide load.
(2)pH值對生物脫硫效果的影響
(2) Effect of pH Value on Biological Desulfurization
pH值影響著無色硫細菌的活性及廢水中硫化物的存在狀態。無色硫細菌適應的pH值范圍較廣,但大多數細菌適宜的pH范圍為6~8。pH值確實與反應器的硫化物去除負荷呈直線關系。
PH value affects the activity of colorless sulfur bacteria and the existence of sulfide in wastewater. Colorless sulfur bacteria can adapt to a wide range of pH values, but most bacteria can adapt to a range of 6-8. The pH value does have a linear relationship with the sulfide removal load of the reactor.
(3) 反應器及填料的影響
(3) Effect of reactor and packing
Buisman等用3種反應器:完全混合反應器(CSTR)、旋轉反應器及式反應器,研究無色硫細菌脫硫的適用性。在硫化物出水濃度低于2mg/L的條件下,3種反應器的去除率分別是:2.4、10、11kg/m3·d,3種反應器所需的停留時間分別為:35、10、13min。
Buisman et al. studied the applicability of colorless sulfur bacteria desulfurization by using three kinds of reactors: complete mixing reactor (CSTR), rotating reactor and upflow reactor. Under the condition that the sulfide effluent concentration is less than 2 mg/L, the removal rates of the three reactors are 2.4, 10, 11 kg/m3.d, and the residence time of the three reactors are 35, 10 and 13 minutes, respectively.
(4)硫化物的負荷對生物脫硫過程效果的影響
(4) Effect of sulphide loading on biological desulfurization process
能否在高硫化物負荷下保持較好的脫硫效果,是衡量脫硫反應器的一個重要指標。硫化物容積負荷越高,微生物脫硫反應器越能保持良好的運行效果,且不易發生出水中SO42-濃度升高的現象,運行條件易于控制,運行效果較為穩定。
Whether the desulfurization effect can be maintained under high sulfide load is an important index to measure the desulfurization reactor. The higher the sulfide volume load, the better the microbial desulfurization reactor can maintain good operation effect, and it is not easy to increase SO42 - concentration in effluent. The operation conditions are easy to control and the operation effect is more stable.
Today's wonderful content will be introduced here for the time being. If you have other places to add, you are welcome to leave a message and comment on the official website of biogas biological desulfurization: http://www.fengkecheng.cn, or call our hotline directly. We will give you a satisfactory answer!